Installation Instructions

Minimum Required:

9" or 12" Moist Stop Flashing (or comparable)
TremSeal U1400 or Comparable - Polyurethane Caulking
8D Galvanized Nails
Paslode Impluse Nail Gun or Hand Nail if Temperature is low

Vinyl Windows and Doors Procedures

1. Openings must be plumb, square & level to achieve maximum unit performance & operation.
2. Flashing is stapled to the opening with a required overlap of 9" (no less then width of flashing) past edge of opening. Staples should not be within 3" from the nailing fin. Any windows that are stacked with 4 x 4's between should be double flashed.
3. Apply a continuous bead of caulking to back side (interior) of the window and doors nailing fin, including the head. Apply a continuous bead of caulking (interior) across sill and up the jamb 6 inches on the door, as well as, the bottom of the door opening and across the opening jambs.
4. Window/Door is set in opening on a level sill. Window/Door is shimmed where needed.
5. Doors and operable windows are checked for smooth operation. Vents are closed prior to nailing of the door/ window. All reveals are checked.
6. Window/Door jambs, head & sill are fastened 10" maximum distance apart.
7. Exterior bead of caulking must be applied (Butter Caulk). Caulking should be spread over the nailing fin to cover all nail holes, nail heads and seams in windows. Installer must also seal the edge of fin to the flashing paper.
8. Apply a bead of caulking to the head (outside) nailing fin prior to applying flashing. Always seal head of window/door to header & apply flashing paper to top of window/door.
9. Make sure window is checked for smooth operation, even reveals & bows or warping in the frame.

CAUTION: The use of peel and stick flashing isn't recommended also do not over pack insulation or use expandable type foam insulation materials which may result in bowed jambs and difficult operation causing the window warranty to be voided.